Description
MG Chemicals 427 SUPERWICK #5 Brown Non-Static Solder Wick 0.125" Diameter 5ft.
The MG Chemicals 427 SUPERWICK #5 Brown Non-Static Solder Wick is designed for efficient and precise removal of solder in electronic repair and rework tasks. This 5-foot desoldering braid features a 0.125-inch diameter and is non-static, making it safe and ideal for use with sensitive electronic components.
Features
-
High Efficiency: Excellent wicking action for quick and effective solder removal.
-
Non-Static: Safe for use with sensitive electronic components.
-
Precise Diameter: 0.125-inch diameter suitable for a wide range of applications.
-
Color-Coded: #5 brown braid for easy identification.
-
Length: 5 feet, providing ample material for multiple uses.
Specifications
-
Length: 5 feet
-
Color: Brown (#5)
-
Diameter: 0.125 inches (3.2 mm)
-
Material: Copper braid
-
Flux: Rosin
-
Non-Static: Yes
Example Use Scenario
The MG Chemicals 427 SUPERWICK is ideal for desoldering larger components from PCBs. For instance, when replacing a large through-hole component such as a power transistor, the SUPERWICK effectively removes the excess solder, allowing for clean and precise installation of the new component. This braid is particularly useful in applications involving sensitive electronic components, ensuring that no static electricity is introduced during the desoldering process.
How to Use MG Chemicals 427 SUPERWICK
-
Preparation:
- Ensure the work area is clean and well-lit.
- Secure the PCB or component to prevent movement during the desoldering process.
-
Application:
- Select the appropriate size of SUPERWICK for the job.
- Place the end of the braid over the solder joint to be desoldered.
-
Heating:
- Heat your soldering iron to the appropriate temperature.
- Place the soldering iron tip on top of the braid, directly over the solder joint.
- Allow the heat to transfer through the braid to the solder, which will then be wicked up into the braid.
-
Removal:
- Once the solder has been absorbed, remove the braid and soldering iron from the joint.
- Cut off and discard the used section of the braid.
-
Cleaning:
- Inspect the area to ensure all solder has been removed.
- If necessary, repeat the process with a fresh section of braid until the joint is clean.
Additional Information
Tri-Tek Electronics is an authorized distributor of MG Chemicals products, ensuring you receive full manufacturer warranty coverage and the best pricing and factory support.
