MG Chemicals 444 SUPERWICK #4 Blue Non-Static Solder Wick 0.10" Diameter 25ft.
The MG Chemicals 444 SUPERWICK #4 Blue Non-Static Solder Wick is designed for efficient and precise removal of solder in electronic repair and rework tasks. This 25-foot desoldering braid features a 0.10-inch diameter and is non-static, making it safe and ideal for use with sensitive electronic components.
Features
-
High Efficiency: Excellent wicking action for quick and effective solder removal.
-
Non-Static: Safe for use with sensitive electronic components.
-
Precise Diameter: 0.10-inch diameter suitable for a wide range of applications.
-
Color-Coded: #4 blue braid for easy identification.
-
Length: 25 feet, providing ample material for extensive use.
Specifications
-
Length: 25 feet
-
Color: Blue (#4)
-
Diameter: 0.10 inches (2.54 mm)
-
Material: Copper braid
-
Flux: Rosin
-
Non-Static: Yes
Example Use Scenario
The MG Chemicals 444 SUPERWICK is ideal for desoldering components from PCBs, such as removing a faulty multi-pin IC from a motherboard. By using the SUPERWICK, technicians can efficiently wick away the solder, allowing for clean and precise component removal. This braid is particularly useful in applications involving sensitive electronic components, ensuring no static electricity is introduced during the desoldering process.
How to Use MG Chemicals 444 SUPERWICK
-
Preparation:
- Ensure the work area is clean and well-lit.
- Secure the PCB or component to prevent movement during the desoldering process.
-
Application:
- Select the appropriate size of SUPERWICK for the job.
- Place the end of the braid over the solder joint to be desoldered.
-
Heating:
- Heat your soldering iron to the appropriate temperature.
- Place the soldering iron tip on top of the braid, directly over the solder joint.
- Allow the heat to transfer through the braid to the solder, which will then be wicked up into the braid.
-
Removal:
- Once the solder has been absorbed, remove the braid and soldering iron from the joint.
- Cut off and discard the used section of the braid.
-
Cleaning:
- Inspect the area to ensure all solder has been removed.
- If necessary, repeat the process with a fresh section of braid until the joint is clean.
Additional Information
Tri-Tek Electronics is an authorized distributor of MG Chemicals products, ensuring you receive full manufacturer warranty coverage and the best pricing and factory support.
