Description
Tri‑Tek CORD‑1‑705 7.5 ft 18 AWG NEMA 5‑15P → IEC C13 Power Cord
Tri‑Tek Electronics – Authorized Distributor
Tri‑Tek Electronics, with a retail location in Mesa, AZ, is proud to offer the CORD‑1‑705 power cord with full manufacturer warranty support and local technical assistance for installers, IT technicians, and hobbyists in Phoenix, Mesa, Chandler, Tempe, Gilbert, Scottsdale, and surrounding areas.
Product Description
The CORD‑1‑705 is a fixed-length, molded AC power cable designed for reliable mains power delivery in IT, home theater, networking, and general electronics applications. It features:
-
NEMA 5‑15P (standard U.S. 3‑prong plug) on one end
-
IEC 60320 C13 female connector on the other end
-
7.5 ft (≈ 2.29 m) total length
-
18 AWG, 3‑conductor cable
-
Rated for typical loads up to 10 A / 125 V (check your device specs)
-
Molded strain relief on both ends
-
Durable PVC jacket, flame rated to standard industry norms
Because this is a Special Purchase, Limited Stock item, quantities are constrained and availability is on a first‑come basis. Once it’s sold out, replacement lead times may apply.
Features & Benefits
| Feature |
Benefit / Use Case |
| 7.5 ft length |
Offers flexibility in routing while keeping cable slack manageable in racks or desk installations |
| Standard 5‑15P to IEC C13 |
Compatible with most PCs, network switches, UPS units, monitors, and many electronic devices |
| 18 AWG conductors |
Adequate gauge for typical office or rack loads up to ~10 A |
| Molded strain reliefs |
Reduces stress on terminations and increases mechanical durability |
| Locally stocked by Tri‑Tek |
Faster fulfillment and local support from Mesa, AZ |
Typical Installation Scenario
An installer is mounting a small network switch in a wall cabinet that sits about 7 feet from a power outlet. The 7.5 ft length of CORD‑1‑705 is just enough to connect the device without excessive slack. The molded ends and proper strain relief help maintain a clean, professional installation. Because Tri‑Tek has local stock in Mesa, AZ, the installer can quickly procure replacements or spares for job sites around Phoenix.
Notes & Recommendations
-
Verify that your device’s current draw does not exceed the rating for 18 AWG (commonly ~10 A at 125 V)
-
Avoid bundling tightly with high-heat or high-current cables to prevent undue heating
-
Inspect for any cuts, abrasion, or damage before use; replace immediately if any compromise in insulation is found
-
Because this is a Special Purchase / Limited Stock item, stock levels are subject to change — order promptly to reserve units
