Power Strips
Tripp-Lite 1U 15A Rackmount Power Supply 12-Outlet
TrippLite RS-1215, 1U 15A Rackmount Power Supply 12-Outlet 1U Rack-Mount Power Strip, 120V, 15A, 5-15P, 12 Outlets (6 Front-Facing, 6-Rear-Facing), 15 ft. (4.57 m) Cord Designed for standard 19-inch racks (1U high) 12 outlets (6 front / 6 rear) 15-amp circuit breaker 15-ft. (4.57 m) cord This product is covered by a Lifetime Limited Warranty
$121.80 $95.99
Radio Design Labs Power Distributor - Switching
Radio Design Labs ST-PD5U, Power Distributor - Switching Radio Design Labs' ST-PD5U is the ideal choice where power distribution from a current-limited switching power supply is needed. It is suitable for powering up to five modules from a single power supply. The current limiting circuitry in many switching power supplies will cause the supply to shut down upon power-up when a high current capacitive load is connected. Upon application of power, the ST-PD5U ramps the voltage up, charging any load capacitance as quickly as possible, then switching full voltage to the load. If reverse polarity is connected to the input, the ST-PD5U disconnects the load until the condition is corrected. In system design, various modules are frequently operated from a single power supply. Good engineering practice requires that the power wiring to each module originate at the power supply output. The ST-PD5U serves as the power source for each of five modules. A single ST-PD5U can provide power to RDL’s floating modules. A separate ST-PD5U can provide power to ground-referenced modules. (Do not attempt to intermix floating and ground-referenced modules from a single ST-PD5U.) Note: If using a linear power supply, distribute the voltage to multiple modules using an RDL ST-PD5 Wherever power distribution from a switching power supply is needed, the ST-PD5U is the ideal choice. Use the ST-PD5U combined with other RDL RACK-UP®, STICK-ON®, Flat-Pak™ or TX™ series products as part of a complete audio/video system Features: Distribution of 24 Vdc Power Soft-Start from Switching Supply Distribution of dc Power Up to 5 Power Distribution Points Voltage Presence Indication Reverse Voltage Protection Typical Performance: Input/Output Voltage: 24 Vdc @ 2 A (Intended for use with current limited switching supply) Number of Outputs (5): Total load current must not exceed 2 A Indicators (2): POWER LED and FAULT LED
$150.60 $112.95
